Are you a 3D artist? Are you looking for some inspiration? Do you just want to collaborate or know who your fellow ModDB artists are? Doesn't matter what application you use or how you do it... if you're a modeller, animator, skinner or looking at getting started with 3D, then this is the group for you!
this is my first real try at sculpting, made from a sphere in Zbrush, no references used so far, which might have been to my disadvantage.
Used Zbrush and a wacom tablet.
time spent: around 2-3 hours.
looks good just the shoulder blades only thing I can see!
No reference is ALWAYS a disadvantage :P
I agree about the shoulder blades, they could use some work. References are always good to have around (I would actually say that they are a must have). You might want to also check the side view again - especially the back because it is really flat in this model. Again, any reference you can find will make a huge difference. Keep up the good work.
thanks a lot for the critisism, I believe i wont do much with this model, however it was my first sculpt in Zbrush, i have done a bit of "sketch sculpts" or what to say, less serious chest sculpts so to say in the past. I am aware of the back area being bad, as i know the anatomy for the chest and stomach better than for the back.
Right now iam trying on a face model, ill post it here later on.
Thanks a lot for the critisism
As far as using no references go, I would say this is a very decent go at a torso, certainly not the worst I've seen. I agree with the others about the shoulder blades, they come out as a bit odd.
Either way, it's still a good attempt without reference, and I'm sure you would do a much better job with reference, keep at it!